耐酒精pp油墨+pp耐酒精油墨
本产品是选用高档进口树脂和高级颜料经过细制研磨加工组合而成，特别适用于移印及丝网高速印刷，不拉丝、不毛边、不堵网、印迹饱满、遮盖力强。主要用于己处理及大部份未处理之聚丙烯pp、opp、cpp、bopp制品。产品特性：1、 不拉丝、不毛边、不堵网、印迹饱满、遮盖力强。 2、 光泽好、手感好，平坦性良好、表面光洁；3、表面硬度好，耐冲击性能强、抗刮伤； 4、 耐酒精程度佳； 产品说明： 1、 细度：4 μ以下。2、适合于40t~165t（100目~420目）网版印刷，以120t聚酯单丝、感光胶网版计算涂覆盖面积每公斤达35~40㎡。3、表干5分钟，彻干24小时，附着力测试应在24小时后进行。使用方法：1．用b-07b专用稀释剂进行稀释，使用前应充分搅拌，用后随时密封。2．网版塞网时可用718洗网水清洗。3．不得与其它类型油墨混合使用。4．对于表面张力较小的材料，有可能产生附着力不佳的现象，可先用我司b-9240处理水或火焰处理法对底材进行处理后印刷，这样可以提高油墨的附着力。注意事项：1．各种物料的外观相似，但可能会是不同的材料，客户需先试印，确其符合要求后，再批量生产。2．如出现拉丝或散开现象，可适当加入一些慢干膏即可。3．环境温度过高，将会影响油墨原有质量。 4．请远离火源，避光保存。thisproduct is made of high-gradeimported resin and pigment throughfine grinding senior systemcombination, especially suitable forprinting and screen printed,not drawing, no flash, no clogging,imprinted full, strong hidingpower. mainly used for theirtreatment and most untreatedpolypropylene pp, opp, cpp, boppproducts. product characteristics:1, not drawing, no flash, noclogging, imprinted full, strong hidingpower. 2, good gloss, feelgood, flatness, good surface finish; 3,surface hardness, impactresistance performance is strong, scrapingresistance; 4, excellentresistance to alcohol degree; productdescription: 1,: 4 μfollowingfineness. 2, suitable for 40t~165t (100 heads ~420 head ) screenprinting, with 120t polyestermonofilament, photosensitive adhesivecoated screen calculation areaevery kilograms amount to 35~40 ㎡.3, 5 minutes into dry, dry 24hours, adhesion testing should beperformed within 24 h after.method of use: 1 with b-07b specialdiluent for dilution before use,should be fully stirred, use atany time after the seal. 2 screenplug network when available 718washing network water cleaning. 3may not with other types of inkmixing. 4 with small surface tensionof the material, are likely tohave poor adhesion phenomenon, can bethe first to use our b-9240to treat water or flame treatment methodfor substrate processingafter printing, this can improve the inkadhesion. note: 1 allkinds of materials, similar in appearance, butmay be of differentmaterials, customers need to try to make theirmark, to meet therequirements of mass production, again. 2 such asdrawing or spreadphenomenon, may be appropriate to add some slowdry plaster. 3 theambient temperature is too high, will influencethe quality of theoriginal ink. 4 stay away from fire source,preserved withoutlight.

---

上海凯贤科技印刷有限公司
王小姐
18201776975
上海市嘉定区外冈镇沪宜公路6106号