英国ttipl-p系列可编程稳压电源pl155p pl303p pl303qmd-p
pl-p系列是tti最新的线性稳压电源系列可编程产品。有手动控制的功能，但增加了全面的远程控制功能。
超紧凑型架模块尺寸非常适合安装在机架上的测试系统，而保留台式应用的手动控制程序。
为了满足今天的工程师们的不同需求，提供一系列的接口。rs-232接口，usb和lan（以太网）与lxi支持提供标准。
每个数字总线接口提供的电压，电流控制，输出开/关，加回读电压，电流和地位。
产品特点：
高性能的线性稳压电源
全数字化远程控制和读出
rs-232接口，usb和lan（以太网）
lan接口符合lxi标准
接口的光电隔离输出
ivi驱动器提供
v模拟远程控制和我（非隔离）
简单的主从式并行布线模拟输出
季度架3u超紧凑的尺寸
高功率密度达90瓦特输出
宽范围的单和双输出模型；
按新的pl系列手动控制功能
    产品型号/规格：
pl155-p - 0to15v at 0 to 5a
pl303-p - 0to30v at 0 to 3a
pl601-p - 0to 60v at 0 to 1.5a
pl303qmd-p - 2x(0 to 30v at 0 to 3a)
digitalbusinterfaces - rs-232, usb, lan (lxi)
fullremotecontrol and read-back using rs-232, usb or lan (lxi-c).allinterfaces are at ground potential and opto-isolated fromtheoutputs.
note:remote/localsense, and operational mode (pl303qmd-p) are manuallyselectableonly.
rs-232
standard 9-pindconnector. baud rate 19,200 max.
usb
standardusbhardware connection. operates as a virtualcomport.
ethernet(lan)
standard10/100base-t hardware connection. icmp and tcp/ip protocol forconnectionto local area network or direct connection to asinglepc.
lxicompliance
lan interfaceiscompliant with lxi-c. (lxi is the abbreviation for lanextensionsfor instrumentation).
gpib (only withoptiong)
conformswithieee-488.1 and ieee-488.2.
digitalprogrammingperformance
voltagesetting
settingresolution:1mv
setting accuracy: +/- (0.05% +10mv)
currentsetting
settingresolution:0.1ma (0.01ma on 500ma range)
setting accuracy: +/- (0.3% +0.005a) to 3a, +/- (0.5% +0.005a)to6a, +/- (0.3% +0.5ma) on500marange.
programmingspeed
commanddelay:typically <80ms (this must be added to any of thefiguresbelow)
voltage up time: typically <45ms* to 1%
voltage down time: typically <20ms* to 1% (full load);typically<150ms* to 1% (no load)
* the up anddowntimes vary with model, current range and voltage step size.moreinformation is contained in the operating manual which canbedownloaded from our web site.
analogremotecontrol (single output modelsonly)
non-isolatedanalogvoltage control of voltage and current. analog controloutputs arealso provided to enable easy parallel connection ofmultiple unitsin a master-slave configuration.
note that the pl303qmd-p does not have analogremotecontrol.
scaling
referencepoint:all control voltage are referenced to the positiveoutputterminal
set voltage input: 0v to 10v sets 0 to 100% of rated output (e.g.0to 30v for pl303-p).
  alternativescaling of 0v to 5v(selectable using internal link).
set current input: 0v to 10v sets 0 to 100% of rated output (e.g.0to 3a for pl303-p).
  alternativescaling of 0v to 5v(selectable using internal link).
voltage output: 0 to 100% of rated output voltage generates 0vto5v.
current output: 0 to 100% of rated output current generates 0vto5v.
accuracy
setvoltageinput: +/- (0.3% +10mv); input impedance = 100kohm
set current input: +/- (0.5% +0.005a); +/- (0.5% +0.5ma) on500marange
input impedance = 64kohm
voltage output: +/- (0.3% +10mv);outputimpedance = 125ohm
current output: +/- (0.5% +0.005a); +/- (0.5% +0.5ma) on500marange; outputimpedance = 125ohm
remoteanalogon/off control (single outputmodelsonly)
non-isolatedterminalwhich sets the output to off when pulled low by gatesignal or relayclosure. signal is reference to the positive outputterminal.
note that the pl303qmd-p does not havethisfacility.
rearterminals
power andsenseconnections are duplicated on the rear panel using ascrew-lessconnector block.
digital bus interfaces - rs-232, usb,lan(lxi)
note: theabovespecifications are additional to the manual controlspecificationswhich can beseen here.
generalspecifications
input
ac input: 230vacor 115v ac +/- 10%, 50/60hz. installation category ii
input power: single output models - 280va max.; dual output models-560va max.
temperature&environmental
operatingrange:+5oc to +40oc, 20% to 80% rh
storage range: -40oc to + 70oc
environmental: indoor use at altitudes up to 2000m, pollutiondegree2.
cooling: intelligent variable-speed low noise fanassistsconvection.
safety&emc
safety:complieswith en61010-1
emc: complies with en61326
physical
size:singleoutput models - 107mm x 131mm (1/4 rack 3u) x343mm, 
dual output models - 214mm x 131mm (1/2 rack 3u) x 288mm
triple output models - 321mm x 131mm (3/4 rack 3u) x 288mm
(sizes exclude feet, knobs and terminals).
weight: single output models - 4.55kg (10lb); 
dual output models - 9.05kg (19.9lb)
triple outpuut models -13.0kg(28.6ib)
driversoftwaresupplied
ividriver
an ivi driverforwindows is supplied. this provides support for commonapplicationssuch as labview*, labwindows*,hpvee*etc.
usbdriver
aninstallationfile is supplied which calls a standard windows*usbdriver.
* labviewandlabwindows are trademarks of national instruments. hpvee(nowagilent vee) is a trademark of agilent technologies. *usbinterface is supported for windows 98-se, 2000, xp,andvista. windowsis atrademark of microsoft.
options
rackmount(rm450)
19 inch 4urackmount suitable for up to four single power supplies, two dualpowersupplies, or any mixture. blanking plates are provided forunusedpositions. the 4u height provides limited ventilation spaceaboveand below the power supplies.
gpibinterface(option g)
gpib(ieee-488)interface fitted in addition tootherinterfaces.

---

深圳市金启泰电子有限公司
罗拥杰
13923857622
南湾街道下李朗社区平吉大道建昇大厦A613-2