带温控uhp-100-280w/85-260v点灯板主要突出特点:
1、  直接接入110v或220v交流电压(适应电压85-260v/ac)。功率因数0.99(pf:0.99)。
2、  5v/dc控制开机和关机(5v与主机隔离)，5v控制灯功率减半。
3、  灯功率大小用户可以根据需要进行调整。功率减半多少瓦也可调整。
4、  带有温度控制功能,当风机出现故障时点灯板温度升至80-90度时会自动开闭，温度降至正常后会自动恢复开机。
5、  适用于85v管压,启动电压3-5kv的uhp灯泡配套。
6、  启动触发时间3-5秒(可根据用户要求设置)，二次启3-5分钟(可根据用户要求设置)。
7、  带温控uhp-100-280w/85-260v点灯板有二种输出方式:
a、直接输出高压适用于灯离点较近的设备配套,比如lcd投影机。
b、高压包外置式,能将点灯板和灯分开较远距离,通常在1-10米之间。适用于探照灯、uhp灯老化台、医疗设备配套。
lighting board salient features:
1、direct access to 110v or 220v ac voltage (adaptation to voltage 85-260v/ac). the power factor of 0.99 (pf: 0.99).
2、5 v / dc control startup and shutdown (5v host isolation) 5v control lamp power halved.
3、the lamp power size of the user can be adjusted as needed. power is reduced by half the number of watts is also adjustable.
4、 with temperature control, lighting plate temperature rose to 80-90 degrees when the fan fails automatically opening and closing, the temperature dropped to normal after recovery boot.
5, suitable for 85v tube pressure, supporting start voltage 3-5kv uhp lamp.
6, the start trigger time 3-5 seconds (based on user requirements), secondary kai 3-5 minutes (can be set according to user requirements).
7, the thermostat uhp-100-280w/85-260v lighting board two kinds of output ways:
a direct output of the high voltage applied to the lamp from a point closer equipment for, such as lcd projectors.
 b, ignition coil external, can separate lighting board and lights than distance, usually between 1-10 meters. applied to the beam lamps, searchlights, uhp lamp aging units, medical equipment supporting.

---

深圳市研翱电子有限公司
朱丹
18926548327
深圳市南山高新科技工业园区360087200@QQ.com