latest firmware version v1.39 ! support 2008 models ! support saab 9-5 and saab 9-3 can ! covers almost all opel cars from 1992 - 2008, even new cars with can-bus based diagnostic, such as vectra-c,astra-h, zafira-b ! op-com is a pc based opel diagnostic program. this interface can read out and clear fault codes, shows you live data, lets you to perform output test, and supports remote, and keyprogramming. the program supports many control units, such as engine automatic transmission abs airbag engine cooling module instrument cluster electronic climate control body control unit manyothers... since opel uses many pin in the on-board diagnostic connector, the diagnostic interface works as a multiplexer, and selects the appropriate pin for communication. pin3, pin7, pin8, pin12 =serial link (iso9141, kw81, kw82, kwp2000) pin6-pin14 pin3-pin11 pin1 hscan - dual-wire, high speed can-bus, 500 kbps mscan - dual-wire, medium speed can-bus, 95 kbps swcan - single-wire, low speedcan-bus, 33.3 kbps fault codes will be shown with all available information: full fault code text description full status information (present, not present, intermittent) you can print out, save, orcopy the fault codes to any other application. from the fault codes window, you can go directly to the measuring blocks window. the program shows you measuring block information on many controlmodule, you can choose anything from the list on your own. the program is capable of showing 8 measuring block parameter simultaneously. the sample rate is depends mostly on the communicationprotocol. for example, older system, like omega-b x 25 dt engine (iso-9141-2) can be very slow, during communication, while newer multec, or bosch units are faster (using kwp-2000), and the newestcan based control units are very fast! you will get a feedback on the state of the activated output. this will helps you to find the failed components more easily. with op-com, you can learn keys toimmobiliser, and remote keys to the central door locking, or alarm. you can also reset, and program the following immobiliser related items: ecm, bcm, ipc. you will need the vehicle security code,which can be found on the car-pass. you can also reset, and program the service interval reminder on astra-g, zafira, corsa-c, meriva, tigra-b you can code sab6, and sab8 airbags with the software.the diagnostic inteface is usb port based, so there will be no compatibility issues, with serial to usb converters. the speed of the communication over the usb-bus is enough to handle the awesomespeed of the high-speed can-bus systems, which is currently 500kbps. this is the main reason, why only the usb port based interface is available for can-bus. # note: the program can only be used witha special interface hardware. a simple serial or usb port based standard interfaces (k, kkl, etc) cannot be used !

---

深圳市车博通科技有限公司
蒋彬
13590430767
深圳市南山区登良路商服大厦东702